Page 402 - Amsco 2023 Catalog

Profile Cylinder Accessories Rekeying Instructions

! Rekeying should be done by a qualified locksmith. ! When rekeying a CES cylinder using CES pins, use the CES pin
! Cylinder designs vary. HOPPE supplies CES brand number that corresponds with the measured key cut.
cylinders and non-logo cylinders. ! When rekeying a CES cylinder using Schlage® pins, use the
! Cylinders feature Schlage® SC1 keyways and may be Schlage® pin number that is one less than the measured
rekeyed using Schlage® rekey kits. key cut. A key cut measuring 4 uses a #3 Schlage® pin.
! Cylinders should be rekeyed to an existing Schlage® key ! When rekeying a non-logo cylinder using CES pins, use the CES pin
whenever possible. number that is one higher than the measured key cut. A key cut measuring
! The HOPPE key gauge measures key cuts 1 through 9 the 4 uses a #5 CES pin.
same as a Schlage® key gauge. ! When rekeying a non-logo cylinder using Schlage® pins, use the
Schlage® pin number that corresponds with the measured key cut.

850-8785231 850-8750635 850-2667482 850-2426890
Key Blanks - Schlage® 5-Pin Construction Key with Cylinder Gauge. Construction Key 8mm Square Construction Key
Long Version (Blue) Short Version (Black)
Steps to Rekey CES Cylinder with Plastic Insert Steps to Rekey HOPPE Cylinder with Set Screws
1. Remove PLASTIC INSERT 1. Remove one SET SCREW at a

using REMOVAL TOOL as time using 2 mm HEX
shown and tap out PINS WRENCH as shown and tap
and SPRINGS out PINS and SPRINGS

850-2000899 850-8771719 850-3475773 850-8762427 850-3459001
Removal Tool Plastic Insert Part # Description Set Screw 2mm Hex Wrench 30 cylinder capacity Key Kit
850-8785239 Standard - 100 cylinder capacity Contains Schlage® Pins
Contains CES Pins

2.
Determine CORE PIN size with KEYING GAUGE

3. 1. Insert desired CORE PIN into the appropriate PLASTIC SET
cylinder pin hole.
Note: For cylinder designs featuring six pin holes, the innermost PLUG SCREWS
hole (furthest from the key face) is left blank. SPRINGS SPRINGS
2. Insert HOUSING PIN
3. Insert SPRING HOUSING OR HOUSING
4. Repeat until all PINS have been replaced and (TOP) (TOP)
install PLASTIC INSERT OR install SET SCREW PINS PINS
and repeat until all PINS have been replaced. CORE CORE
(BOTTOM) (BOTTOM)
PINS PINS
400
© 2023 PGI.